skip to Main Content


Industrial Floors

Industrial floors need to withstand very demanding conditions (abrasion, impact, chemical attacks). Self-levelling overlayments are increasingly used as they enable a quick return to service. These cementitious mortars are used as the last coat of the floor system or as an underlayment layer prior to resin coating. They are found on numerous industrial job-sites such as: logistic hubs, warehouses, airports, shopping malls. Typical thickness of application: 25-40 mm.

Both long service life and fast return to service are requested for industrial jobsites. This comes from a right selection of additives, in addition to the binder mix design.

Comparative table

Additive Types
Active matter (%)
Dry content (% by mass)
Lithium sulfate monohydrate (%)
Bulk density
pH (5% solution)
Particle size (% > 600 µm)
Particle size (% > 500 µm)
Particle size (% < 125 µm)
Particle size (% > 200 µm)
Viscosity (mPas)
Alkali as Na2O eq (% by mass)
Chloride content (% by mass)
Ash Content (ppm)
Water content (%)
Hydroxyl number (mg KOH/g)
CE Marking
Formaldehyde regulation
Back To Top